Flojet RV Macerator Pump [18550000A]

RV Macerator Pump

Enhance your RV holding tank service with this Flojet waste pump. It offers amazing flexibility, allowing you to empty black and grey water tanks not only at traditional dump stations but also down a toilet, into your home sewer clean - out, septic tank, or a mobile waste wagon.

This pump is incredibly fast, emptying a typical 30 - gallon holding tank in under three minutes. The time might increase a bit if you pump beyond 25 feet. It can break down and pump all the waste and tissue usually found in RV waste systems. With the same high - quality Jabsco design seen in boat stores globally, say goodbye to the hassle of handling and rinsing a dirty 3 - foot sewer hose. Instead, use a cleaner and more manageable garden hose. You can even pump uphill and around corners, making your RV experience much better!

Features:

• Quickly and cleanly evacuate waste tanks
• Empty black and grey water holding tanks right at home
• Grind waste while pumping
• Built - in impeller protection for a longer lifespan
• Up to 13 GPM flow for fast and clean tank evacuation

Easy to Install

Since it's self - priming, you can place it up to four feet above the tank liquid level. The intake port fits a 3 - inch ID slip - on hose, and the discharge port takes a 1 - inch ID hose. Once installed, you can empty the holding tank into any nearby sewer receiver, like your home's sewer clean - out.

Applications

• Empty holding tanks and skip the dump stations
• Transfer waste from recirculating toilets to the main holding tank

Impeller Release Feature

If the impeller gets stuck after long periods of non - use, just insert a screwdriver into the motor shaft slot and turn the shaft clockwise as shown to free it up.

Specifications:

• Pump: Self - Priming Flexible Impeller with Stainless Steel Wearplate
• Impeller: 'Jabsco Nitrile' compound
• Macerator: Stainless Steel Cutter reduces particle size to 1/8 inch (3mm) maximum
• Seal: Lip Type
• Ports: Inlet RV model - 3 inches (76mm) hose; Outlet - 1 inch (19mm) Hose Barb

Motor: Permanent Magnet Type, Fully Enclosed, with Stainless Steel Shaft. It includes an Impeller Protection Device that shuts off the pump after 20 seconds of running dry.

Complies with USCG Regulation 183.410 & ISO 8846 MARINE for Ignition Protection

Weight: Approximately 3.5 lb (1.6 kg)

WARNING: This product can expose you to chemicals including NICKEL (METALLIC) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.

- cis2:mm1pm5ht -
Owner's Manual (pdf)
Brochure (pdf)

Using the Flojet RV Macerator Pump is a breeze. First, install it. Since it's self - priming, you can place it up to four feet above the tank liquid level. Connect a 3 - inch ID slip - on hose to the intake port and a 1 - inch ID hose to the discharge port. You can then empty your holding tank into a sewer clean - out at home, a septic tank, or other suitable places. It can empty a 30 - gallon tank in under three minutes, but the time may increase if you pump over 25 feet. If the impeller gets stuck after long periods of non - use, insert a screwdriver into the motor shaft slot and turn it clockwise to free it. When it comes to maintenance, the built - in impeller protection device will shut off the pump after 20 seconds of running dry, protecting the pump. However, always make sure there's enough liquid in the tank before starting the pump. Also, be aware that this product can expose you to chemicals like Nickel (Metallic), which is known to cause cancer in California. Check P65Warnings.ca.gov for more information.