Need a thru-hull flush-style transducer? The Tilted Element 525T-LTD/12 suits hulls with a deadrise angle of 8 - 15 degrees, while the 525T-LTD/20 is perfect for those with a 16 - 24 degrees deadrise angle. These transducers adjust for deadrise by angling the internal element. There's an arrow on the housing top, always point it towards the keel for correct orientation, no matter port or starboard installation. With 600 Watts power, 50/200 kHz frequency, and 20/6 degree beam angles, this bronze thru-hull comes with temperature sensing and a 30-foot cable featuring a 10-pin connector.
Using this Furuno transducer is straightforward. First, decide if the 525T-LTD/12 or 525T-LTD/20 suits your hull's deadrise angle. Then, install it on your boat, making sure the arrow on the housing points towards the keel. This gives the internal element the right orientation. When it comes to maintenance, keep the transducer clean. Check the cable regularly for any signs of wear or damage. If you notice the 10-pin connector getting loose, secure it properly. Also, avoid exposing the transducer to extreme conditions. With these simple steps, your transducer will work well for a long time.
