Blue Sea Systems m-Series Mini Red Knob Battery On/Off Switch
Model: 6006-BSS
- Tin-plated copper studs offer great conductivity and resist corrosion.
- 3/8' (M10) ring terminals fit the studs.
- 7/8' (22mm) stud length can take multiple cable terminals.
- The one-piece terminal stud design stays tight over time.
- An isolating cover with snap-on parts protects rear contacts.
- The case allows surface, rear, or front panel mounting.
- It's waterproof (IP66) against powerful water jets.
- One-piece stainless flange nuts make secure connections.
- Breakout tabs let wires access from any direction.
- It's ignition protected, safe for gas-powered boats.
Connects a single battery to a single load group.
Specifications| Switch Type | Single Circuit ON-OFF |
| Color | Red |
| Switch Positions | 2 |
| Battery Combine | No |
| Alternator Field Disconnect | No |
| Maximum Voltage | 48vDC |
| Stud Size | 3/8' |
| Terminal Stud Torque | 120 in-lb (13.56 Nm) |
| Continuous Rating | 300A |
| Intermittent Rating | 500A (5 min) |
| Cranking Rating 30 sec | 900A |
| Battery Inputs | 1 |
| Cable Clearance For 4/0 AWG Cables | 1.12in (28.45 mm) |
| Cable Size to Meet Ratings | 4/0 AWG (120mm) |
| Mounting Holes | Accept #10 Screw |
| Stud Material | Tinned Copper |
| Stud Torque | 120 in-lb (13.56 Nm) |
| Terminal Stud Size | 3/8' - 16 (M10) |
Using this battery switch is easy. First, decide on a mounting location - it can be on the surface, rear, or front panel. Make sure to use #10 screws for mounting. Connect the 4/0 AWG cables to the 3/8' tinned copper studs. Tighten the terminal studs to 120 in-lb (13.56 Nm). This switch is for a single battery and a single load group. Just turn the red knob to switch it on or off. When it comes to maintenance, check the connections regularly to make sure they're tight. The switch is waterproof, but still keep it away from long - term submersion. Since it's ignition - protected, it's safe for gasoline - powered boats, but always follow basic safety rules around fuel. If you notice any corrosion on the studs, clean them gently with a suitable cleaner.
