Product Description
The Blue Sea SMS Surface Mount System Panel Enclosure is a top - notch solution for your ELCI Main circuit breakers and other large - frame devices. Model 3117 - BSS comes with a Dual 120V AC / 30A ELCI Main. It features a glass - filled polycarbonate mounting box and a clear cover, allowing you to easily check the circuit breaker status. The overlapping cover provides strength and extra gasket protection. There's an oversized, seamless PUR gasket formed in place. The easily removable stainless - steel hinge pin makes installation a breeze. A stainless - steel latch secures the cover without penetrating the enclosure. All necessary stainless - steel mounting hardware and waterproof glands are included. It also has LED lights for backlighting and ON indication. This panel enclosure meets ABYC E - 11 when used with an ELCI Main circuit breaker and mounted within 10 feet of the shore power inlet. Specifications include a minimum operating temperature of - 40°C and a maximum of 85°C. Cover screws and hardware are 10 - 32 stainless steel. The enclosure size is 6.0' x 6.0' x 4.0' (152mm x 152mm x 102mm), and the exterior overall dimensions are 7.6' x 7.4' x 4.7' (192mm x 188mm x 120mm). The mounting hardware is 1/4' diameter, #12 (6 mm), and it weighs 7.00lb (3.18 kg). What's in the box? You'll get an SMS Panel Enclosure, two ELCI Main 120V 30A, 30mA (3102), two small wire glands (3124), four medium wire glands (3125), two green 'ON' indicating 120V AC LEDs (8034), two red 'Reverse Polarity' indicating 120V AC LEDs (8066), two LED plugs, twelve circuit breaker mounting screws, six backlit circuit label positions, a Source Selection Label Set (10 labels), two Reverse Polarity labels, two ELCI labels, and a Panel Voltage ID label - 120V AC.
Using this Blue Sea panel enclosure is easy. First, find a suitable location within 10 feet of the shore power inlet. Remove the easily removable stainless - steel hinge pin to open the cover. Install the included ELCI Main circuit breaker and other large - frame devices inside the glass - filled polycarbonate mounting box. Use the provided stainless - steel mounting hardware to secure the enclosure. Connect the wires through the waterproof glands. The LED lights will indicate the ON status and backlight the circuit labels. When it comes to maintenance, keep the enclosure clean. Check the gasket regularly for any signs of wear and tear. If you see any issues with the cover latch or hinge pin, make sure to address them promptly. Always operate the device within the specified temperature range of - 40°C to 85°C. When installing, ensure that all connections are tight and follow the ABYC E - 11 standards. If you need to replace any of the components, refer to the items in the box and use the appropriate replacement parts.
